logo
ProjectEnded

ADvanced Aeroacoustic Processing Techniques

Sector: Aerospace & Defense • Location: France, Netherlands

Source: EU Funding & Tenders Portal

Airbus is currently conducting various experimental studies, dealing with installing microphones on the fuselage, on the wall of a wind tunnel test section or on specific microphone supports on the flow, in order to record the sounds emitted by each aircraft component (i.e. engine, wing etc.). In either case, microphone measurements are polluted by hydrodynamic noise, which hampers the correct ass

Status
Closed
Sector
Aerospace & Defense, Telecommunications, Broadband, Tunnel, Wind
Location
France
Updated
22 Jul 2026
Source
EU Funding & Tenders Portal

ConstructChat

Ask ConstructChat about ADvanced Aeroacoustic Processing Techniques

Pick a question to edit it, or write your own.

First answer free · no account

I am a

Project Information FAQ

Project Information

3 Q
The project “ADvanced Aeroacoustic Processing Techniques” is an infrastructure initiative in the Aerospace & Defense sector, located in France, Netherlands. Taiyo aggregates data on it from EU Funding & Tenders Portal.

Participants

Not available for this record.

Status

Original status

ended

Taiyo status

Closed

Taiyo last update

2026-07-22

Contact

Not available for this record.

Description

Description

Airbus is currently conducting various experimental studies, dealing with installing microphones on the fuselage, on the wall of a wind tunnel test section or on specific microphone supports on the flow, in order to record the sounds emitted by each aircraft component (i.e. engine, wing etc.). In either case, microphone measurements are polluted by hydrodynamic noise, which hampers the correct assessment of acoustic signals emitted from aircraft components, thus leading to very low signal-to-noise ratio. A few methods exist today that can eliminate hydrodynamic noise from acoustic signals. However, the efficacy of these methods strongly depends on various parameters, such as signal-to-noise-ratio, number of microphones, number of incoherent sources etc. No systematic study has been performed so far to assess the parameter boundaries within which acceptable results are obtained (e.g. within 0.5 dB error for example). The ADAPT consortium will improve and optimize the ability of identifying sources emitted by aircraft components by using the most effective techniques out of the three proposed approaches in the call for proposal. These three approaches are: aeroacoustic source separation, de-noising techniques based on cyclostationarity and aeroacoustic sources localization. Through these three approaches, the ADAPT project aims at delivering to AIRBUS a tool dedicated to separating airframe and engine noise components (tonal, broadband cyclostationary components in particular) from hydrodynamic pressure noise and identifying these sources in space, satisfying various technical and economical requirements that will be discussed out with AIRBUS at the beginning of the project.

Location

Country

France

Source

Source

EU Funding & Tenders Portal

URL

More Details

Record type

Project

Sector

Aerospace & Defense, Telecommunications, Broadband, Tunnel, Wind

Article published date

2026-01-15

More on this project

Research

Free account

View all details

You are reading the public part. A free account opens the rest:

  • Every detail on this project
  • News and media coverage
  • Technical research
View all details

Free account · no card · lands you back on this project