Conservation / WL / D5 / Office - Custom Gates ( BABA )

2026-11-03

• 16 ’ long welded gate made from 2 ½ ” square tubing that is ¼ ” thick . • The locking side of the gate needs to have a 10 ” x2 ½ ” x¼ ” plate welded onto the end of the 16 ’ square tube with a ½ ” hold cut into it . • The hole needs to be off centered to allow for a lock shackle to be inserted . • The swivel side of the gate needs to have a 3 ’ long round pile welded to it that is just large enough to slide over the 3 ” pipe that is the swivel pole . • There needs to be a 12 ’ long support bar made from 2 ½ ” square tube welded diagonally from the 16 ’ square pipe to the base of the 3 ” swivel side . • There also need to be a vertical support made from 2 ½ ” square tube welded to the 12 ’ support and the 16 ’ square tube . • The locking pole should be made from 4 ” square tube that is 6 ’ long and ¼ ” thick with a plate welded to the top . • The pole needs to have a 6 ” x7 ” x¼ ” square tube welded onto one for the sides flush with the top of the pole . • There needs to be a 5 ” x¾ ” gap cut into the box to allow gate to be locked . The swivel pole of the gate should be made from 3 ” round pipe that is 7 ’ 6 ” long . • The below ground portion should be 4 ’ long and the above ground section should be 3 ’ long . • There needs to be a cap or welded plate attached to prevent the gate from being lifted off the swivel pole . • The gates should be powder coated yellow . • QTY 8

Alabama

2026-03-27