Exterior Silo / Tank Renovation 2026

2026-11-03

1 Purpose : The Tri - Lakes Bio - Solids Joint Municipal Utilities Commission ( JMUC ) is soliciting bids for the cleaning , priming , coating , and logo reapplication on the exterior of the biosolids storage silo located at the Tri - Lakes Regional Wastewater Treatment Facility in Branson , Missouri . This renovation is intended to preserve the structure ’ s integrity , extend the useful life of all exterior components , and restore the aesthetic and protective finishes to current operational standards . 2 General Requirements : This project includes the complete surface preparation and recoating of the exterior of the biosolids storage silo and its associated metal components , in accordance with current SSPC standards . 3 Scope of Work : 3 . 1 The work shall include all labor , materials , equipment , tools , supervision , and incidentals necessary to complete the cleaning and recoat of the silo tank and all associated structural steel components . 3 . 2 The project also includes the reapplication of the facility ’ s existing logo . 3 . 3 All exterior metal components associated with the silo unless specifically excluded in writing shall be included in this project scope . 3 . 4 Blueprints with silo dimensions and component layout are provided in Appendix A . Contractors are responsible for referencing these blueprints to confirm required areas of work . 3 . 5 It is the contractor ’ s sole responsibility to verify all field measurements and existing conditions for accuracy prior to bidding and beginning work . No change orders will be approved based on incorrect assumptions or measurements . 4 Description of Work : The following work is to be performed : 4 . 1 Abrasive blast cleaning of the entire exterior surface of the silo tank and all attached / associated structural steel . 4 . 2 Surface preparation must comply with SSPC - SP6 ( Commercial Blast Cleaning ) standards using a wet blast method . 4 . 3 Apply a Zinc - Rich primer immediately following surface prep to prevent flash rusting . 4 . 4 Apply a full epoxy prime coat to all prepared surfaces . 4 . 5 Apply a high - performance Polyurethane finish coat in a color that closely matches the existing silo color . 4 . 6 Reapply the existing logo in the current size , location , and color ...

Missouri

2026-04-29