HEAVY DUTY PLATFORM BODY AND AERIAL DEVICE WITH DIGGER

2026-11-03

Specifications include , but are not limited to : GENERAL : This specification covers the State of New Hampshire ' s requirements for a Heavy Duty platform body and telescopic Aerial Lift . Body and lift shall be mounted by successful bidder on a cab & chassis provided by the State . The truck shall be picked up at Mechanical Services by the successful bidder for installation of the lift and body . All cost of transportation to and from the Bureau of Mechanical Services , 33 Smokey Bear Boulevard shall be borne by the vendor . I . CONFIGURATION ; A . UNIT ; B . 1 . Boom shall consist of three sections with two sections telescoped hydraulically . 2 . The boom shall attain an arc travel no less than 80 degrees above horizontal to 18 degrees below horizontal to 98 degrees total . 3 . All sharp edges on the unit and the boom ( s ) shall be rounded for safety . C . PLATFORM ; 1 . Aerial device shall be provided with one removable rotating platform manufactured of steel . 2 . Platform shall be attached to the leveling frame with a self - guided self - latching detachable mount . 3 . In addition to a self - latching pin mechanism , the detachable mount shall have a safety lock pin . 4 . The platform detachable mount shall be hinged to the leveling frame utilizing flanged bearings . 5 . Platform shall include a hydraulic cylinder rotator capable of allowing the operator to move the platform horizontally through an arc of no less than 45 degrees right and 45 degrees left of normal position . 6 . Platform shall be rectangular in shapе . 7 . Platform dimensions shall be 40 " inches x 60 " inches . 8 . Platform rails shall be 40 " inches in height . 9 . Platform shall be built per ANSI A92 . 2 ; 10 . Platform shall be equipped with safety chain on opening . 11 . The platform shall be equipped with two safety lanyard attachments . D . BOOM CONSTRUCTION ; 1 . The boon shall be constructed of high - strength steel rectangular tube section with 80 , 000 - PSI min . 2 . The boom assembly shall include heavy - duty cylinder fittings ; heavy pivot pins and replaceable , ultra - high molecular weight polyethylene wear plates . 3 . The boom shall be equipped with a steel cable carrier mounted external to the boom . 4 . The cable carrier shall have a cover . E . CAPACITY ; 1 . The rated capacity of the platform shall not be less than 500 pounds in any boom position . F . LIFT ; 1 . Lift shall be accomplished with one 7 " I . D . double acting , 62 " stroke cylinder . 2 . Lift cylinder shall come equipped with a holding valve to prevent the boom from falling in the event of hose failure .

New Hampshire

2026-04-28