Interior Renovations for Hand - In - Hand Primary School

2026-11-03

3 . 01 EXAMINATION A . Verify that doors and frames are ready to receive this work ; labeled , fire - rated doors and frames are properly installed , and dimensions are as indicated on shop drawings . B . Correct all defects prior to proceeding with installation . C . Verify that electric power is available to power operated devices and of correct characteristics . 3 . 02 INSTALLATION A . Install hardware in accordance with manufacturer ' s instructions and applicable codes . B . Install hardware using the manufacturer ’ s fasteners provided . Drill and tap all screw holes located in metallic materials . Do not use “ Riv - Nuts ” or similar products . C . Install hardware on fire - rated doors and frames in accordance with applicable codes and NFPA 80 . D . Use templates provided by hardware item manufacturer . E . Do not install surface mounted items until application of finishes to substrate are fully completed . F . Wash down masonry walls and complete painting or staining of doors and frames . G . Complete finish flooring prior to installation of thresholds . H . Door Hardware Mounting Heights : Distance from finished floor to center line of hardware item as directed by hardware manufacturer . I . Set exterior door thresholds with full - width bead of elastomeric sealant at each point of contact with floor providing a continuous weather seal . Anchor thresholds with stainless steel countersunk screws . 1 . See Section 07 92 00 for additional requirements . J . Include in installation for existing doors and frames any necessary field modification and field preparation of doors and frames for new hardware . Provide necessary fillers , reinforcements , and fasteners for mounting new hardware and to cover existing door and frame preparations . 3 . 03 FIELD QUALITY CONTROL A . Perform field inspection and testing under provisions of Section 01 40 00 - Quality Requirements . 3 . 04 ADJUSTING A . Adjust work under provisions of Section 01 70 00 - Execution and Closeout Requirements . B . Adjust hardware for smooth operation . C . Adjust gasketing for complete , continuous seal ; replace if unable to make complete seal .

Georgia

2026-05-10