Liquid Salt Brine Maker

2026-11-03

1 AN AUTOMATIC BRINE MAKER SYSTEM must be a Accubrine ® NXT - Gen automated brine maker or equal and make the salt act as a filter bed as the water moves down through to the sump area and filter screen . The system must be capable of producing , at a minimum , two hundred ( 200 ) gallons of brine per minute or six thousand ( 6 , 000 ) gallons of brine per hour ( based on available water supply of six thousand ( 6 , 000 ) gallons per hour and storage tank configuration static discharge of forty - five ( 45 ) feet head pressure ) and at a minimum meet the following . 2 LIST OF MINIMUM REQUIREMENTS FOR THE SALT HOPPER : The salt hopper must have a minimum capacity of four point five ( 4 . 5 ) cubic yards ; The minimum inside dumping width must be no less than one hundred twenty ( 120 ) inches ; The salt hopper must be constructed of sixteen thousand ( 16 , 000 )- pound tensile - strength fiberglass and isophthalic resin with all inside surfaces coated with a ceramic resin zero point zero five zero ( 0 . 050 ) inches thick ; The vessel must have structural integral ribs allowing flex with the salt hopper from full to empty . The salt hopper must be capable of being cleaned via flush components of the unit , and any disassembly of components for cleaning is not acceptable ; Whether full or empty , the salt hopper must be able to be cleaned by opening the sump outlet cap and water flush valves . If the salt hopper is empty , the inside floor panel must have the capability of being removed for cleaning by attached lifting straps or another method allowing easy removal of the inside floor panel ; There must be a fresh water flushing system to force sediment to and out of the sump . All valves , bulkhead fittings , and related components one ( 1 ) inch and larger must be manifold - type fittings ; There must be a pressure transducer connected to the PLC to activate brine pump on and off and water flow into the salt tank . These levels must be adjustable from the HMI interface and adjustable to within one ( 1 )- inch increments and ; The transducer must have an air capillary to the inside of the salt hopper . 3 AUTOMATIC BRINE MAKER PRODUCTION SYSTEM EQUIPMENT 3 . 1 The vessel must have two ( 2 )- inch male cam - lock - type fittings and on / off ball valves for hose connections ( fresh water , brine return , brine outlet to pump ); 3 . 2 There must be reinforced forklift pockets for moving the salt tank and ; 3 . 3 Three hundred four ( 304 ) stainless steel is required for all metallic items , as it is the most corrosion - resistant of the three hundred ( 300 ) series of stainless steel . 4 LIST OF MINIMUM REQUIREMENTS FOR THE CONTROL SYSTEM : 4 . 1 Brine pumped from the salt tank must be monitored for salt concentration by a sensor which must monitor brine temperature and automatically compensate brine concentration accordingly . Any need for an operator to manually test the brine concentration is not acceptable ; 4 . 2 All brine exiting the salt tank must pass over the brine concentration sensor that monitors brine between zero point zero ( 0 . 0 ) and twenty - seven point zero ( 27 . 0 ) percent concentration by weight ; 4 . 3 The system must come complete with the ability to access the HMI ( operator interface ) via the Internet . The operator must be able to view the brine maker ’ s functions remotely ; 4 . 4 The system must include a two hundred fifty - six ( 256 )- color LCD touch - screen display , minimum seven and one - half ( 7 . 5 ) inches diagonal ; 4 . 5 The information on the display screen must include , but not be limited to : 4 . 5 . 1 Actual brine production concentration as a percentage of sodium chloride concentration by weight ; 4 . 5 . 2 Gallons of fresh water used to make brine ;

Idaho

2026-05-11