Milling , Resurfacing & Shoulder Reconstruction - Various Routes - Robeson

2026-11-03

Notify the Engineer 48 hours before milling or resurfacing will interfere with the existing Signal Loops . Loops may need to be placed in milled surface before resurfacing occurs . Coordinate all signal loop operations with the Engineer . For partial or wheel track milling operations on two - way , two - lane facilities , mill and pave back by the end of each work day . For Partial or wheel track milling operation on multi - lane facilities , the lane being milled may be left closed and paved back within 72 hours . The following options are available during Resurfacing and milling operations on two - way , twolane facilities when the entire roadway or entire lane is to be milled : ( A ) Mill a single lane and pave back by the end of each work day . ( B ) Mill the entire width of roadway and pave back within 72 hours . The following options are available during Resurfacing and milling operations on multi - lane facilities when all lanes or a single lane in one direction are to be milled : ( A ) Mill a single lane and pave back by the end of each work day . ( B ) Mill the entire width of pavement for all lanes to be milled in any direction daily and pave back within 72 hours . Slope the pavement at the beginning and end of the daily milling operation as directed by the Engineer . Sweep and remove all milled material from the roadway as soon as the daily milling operation is completed . Continue milling operations until the section of roadway being milled is complete . Remove any existing pavement adjacent to the milled area that has been damaged and replace it with patch material as directed by the Engineer ...

North Carolina

2026-05-08