MILLING AND PAVING

2026-11-03

 Edge mill 1 . 5 inch of existing asphalt from edge of pavement to a distance adequate to provide proper tie - in within the scope of the project . o All millings are property of the City of Parkersburg it is to be discussed with city personnel on the proper procedure when hauling millings off the project site .  Contractor shall place a 0 . 5 - inch hot laid bituminous asphalt scratch / leveling course on all streets included in this project prior to placement of the wearing course , unless otherwise directed by the Engineer .  Before placement of 1 . 0 - inch hot laid bituminous asphalt a roller pass must be established for City personnel to determine adequate compaction . If batch number changes , then another roller pass must be established . Contractor is responsible for providing compaction testing to establish roller pass .  Place 1 . 0 - inch hot laid bituminous asphalt wearing course in the stated areas after application of scratch / leveling course is completed .  Adjust water valve , manholes , and inlets where applicable . The adjustment will be completed by the use of precast iron risers for sanitary manholes and water valves . Sealing on the inside of the riser ring will be required for all sanitary manholes . The adjustment may be completed by the use of adjustable riser rings for storm water manholes . See attached spec sheets for products .

West Virginia

2026-05-02