Pool Maintenance and Service

2026-11-03

MAIN POOL : • Set up necessary ground de - water pumps and equipment and de - water ground . • Pump outpool . • Remove proper Freeze - Out Plugs as water goes down . • Remove leaves and debris and clean out Main Drain Pits . • Drain and rinse Main Pool . • Pressurewash / acid wash and neutralize pool interiorsurface with proper concentration of Muriatic Acid and degrease surface . • Survey poolsurface with Borough Administrator or designee for anymasonry , tile or jointrepairs . If any , quote price for repair and schedule work to be done as soon as possible . • Replace anymissing or loose tilesin the racing lines . • Filter and all equipment to be surveyed with BoroughAdministrator or designee and recommendationsfor maintenance , repair , etc . are to be made . • Remove manual hydrostat plugs or check if automatic plugs are releasing water pressureunder pool . • Re - install pressure relief plugs . • Remove all inlets , outlets and skimmer winter plugs and store in pump house . • Important Note : Any surface coating for main pool will be evaluated upon draining and cleaning pool . • Apply one ( I ) coat to interior pool surface : apply # 0 washed , bagged sandon the paint on the entire floor for non - skid . Paint shall be Ramuc type DS water based acrylic white paint applied as per manufacturer specifications . • Replace , as needed , vinylstick - on depth markers located on the stainless - steel overflow gutter . • Install dive boards , handrails and ladders . Check for any defect . • Advise Borough Administrator of any concerns or problems . • Every three years , starting after the 2014 bathing season , use a degreasing detergent to clean filter elements . • Remove plugsfrom manifold and store in Pump House . • Wash and clean out debris from filter tank making sure that there is no loose DE in the tank . • Remove sump pump and hose and store in Pump House . • Inspect condition of filter tank interior walls . • Inspect condition of sluicegate . • Make sure all DE grids are clean and inspected for damage . • Install and properly secure DE filter leaves . Ensure seal is tight at manifold on each filter leaf • Insure hold down clamps and bar are properly attached . • Fill filtertank . • Charge filter leaves with DE medium per manufacturer ' s specifications . Pre - coating of leaves by experienced technicians only . • Adjust all valves to provide proper flow rates . Flow rate needs to be a minimum of 1360 gpm . Note : suction • and pressure of system at start - up . Advise operator . • Re - set all fiberglass grating atop filtertank and re - setsame in pump room . • Verify all connections are secure in order to ensure no DE will escape into mainpool . • Advise operator of any concerns , problems , etc . • Do not operate pump without having the DE powder coating the grids . • Connect up freshwater piping from Kiddie Pool Pit to Filter House and beyond and activate . • Remove sump pump and hoses . • Check all valves for proper operation . • Remove inside sump pump , clean pit , replace sump pump and check . • Reinstall fillspout , reconnect waterleveler . • Reinstall chlorinator and connect to storage tanks . • Check all chlorine valves and fittings . • Order 10 new covers for Main Poolfilter leafs and replace the covers that have ripsin them . • Empty tank as needed . • Install new DE bags provided by property . • Advise Borough of any concerns or problems . MAIN POOL PUMP ROOM : • Re - install fillspout . • Re - install water leveler . • Re - install chlorine feeders with new tubing . • Re - install main pool pump and test motor . • Reinstall analyzer probes and calibrate . KIDDIE POOL : • Drain and rinse Kiddie pool . • Remove manual hydrostat plugs or check if automatic plugs are releasing water pressure from under pool . • Pressure / acid wash and neutralize pool interiors . • Re - install pressure relief plugs . • Remove all inlets , outlets and skimmer winter plugs and store inpumphouse . • Advise Borough Administrator of any concerns or problems .

New Jersey

2026-04-29