Purchase 750 15kV EPR Power Cable

2026-11-03

This specification covers single conductor , 750 kcmil compressed stranded copper , 15 kV class III 133 % 105 ° C ethylene propylene rubber ( EPR ) insulated , discharge free or discharge resistant thermosetting rubber based elastomer , copper tape shielded , jacketed power cable to be used on a 12 , 470 / 7 , 200 volt grounded - wye system at 60 Hz . A water blocking compound may be incorporated over the outer metallic shield or under the metallic shield . There shall be no water blocking components in the interstices of the stranded conductor . The cable shall be suitable for direct buried installations in earth , for wet and dry locations , and in open air in sunlight . The cable shall be suitable for operation with the metallic shield grounded at one end only . The cable will typically be installed between the 115 kV / 12 . 5 kV substation transformer and 12 . 5 kV substation feeder breakers . 2 Technical Requirements 2 . 1 Governing Standards The cable shall meet the requirements of these standards except where it conflicts with the requirements of this specification , in which case this specification shall apply . Cable diameters shall conform to those required in the AEIC Standard . ICEA S - 97 - 682 - 2023 , “ Utility Shielded Power Cables 5 - 46kV ” AEIC CS8 - 20 “ Specification for Extruded Dielectric , Shielded Power Cables Rated 5 through 46 kV .” 2 . 2 Cable The cable shall be true triple extruded ( all three layers extruded in one pass ) for simultaneous application of the conductor shield , insulation , and insulation shield .

Nebraska

2026-04-29