REMOVAL AND REPLACEMENT OF A 2 POST ABOVE GROUND VEHICLE HOIST

2026-11-03

Specifications 2 Post Above Ground Vehicle Hoist Replacement General : The purpose of these specifications is to describe the removal and replacement of a 2 Post Above Ground Vehicle Hoist . Contractor Responsibility : It is the contractor ' s responsibility to ensure that all components of the hoist system are in good working order and operate properly upon completion of this project . All measurements and necessary components for accurate quotations are the responsibility of the contractor . We will have a pre - bid walkthrough to show the hoist we currently have . It is the contractor ' s responsibility to ensure we have the same or better when submitting a proposal . Scope of Work : Removal of old existing vehicle hoist and replace with a new 2 Post Vehicle Hoist . The old hoist is to be left on the property when removed from operation . All concrete , electrical , installation of hydraulic lines , hoses , fluids , and any other requirements to make the new hoist fully operational upon completion of project . Hoist requirements : Power Supply 208 - 230v Capacity must be a minimum of 16 , 000 lbs . Motor rating must be a minimum of 4 HP Arm pad height must be a maximum of 5 " The lifting height must reach 6 ' The width between posts must be 10 ' The overhead hydraulic line height needs to clear a 10 ' transit high - top vehicle . The system must have a direct drive system ( No cables or chains ). The arms must be adjustable for vehicles up to 148 " wheelbase . The hoist will need a 3 - stage arm system due to the length of the vehicles serviced by the hoist . Mechanical safety locks must be automatic and must start no more than 5 " off the ground during lifting . All adaptors , arms , and lifting materials need to be supplied . All setup must be included . All training to use the hoist must be included . Hoist Location : All work is to be performed at the Bay Metro Transit main office building property located at 1510 N Johnson Street , Bay City , MI . 48708 . Compliance The contractor will comply with all required Permits , Building Codes and safety regulations . The contractor will provide copies of their liability insurance , workers ' compensation and required bonds prior to any work being performed .

MITN

2026-04-29