Service Body Installation and Upfitting

2026-11-03

Item 1 - One ( 1 ) New 2025 Ford F450 4WD 60CA cab and chassis , DRW ( Dual Rear Wheels ), diesel ( 67 gallons ). ( ITD Plate number T03235 ) Electrical Circuit Breakers All electrical components must be protected by circuit breakers . OE circuit breakers must be utilized if provided and ; A power disconnect switch must be installed between the truck and the Service Body . Location will be inside truck cab within reach of the driver ’ s seat . Wiring Must be continuous and must not be spliced without utilizing weather pack connectors ; Must be securely fastened and located away from all pinch points ; Must be clamped and held in place using stainless steel rubber - insulated , bolt - on cushion clamps ; Passing through bulkheads must be protected with either rubber or neoprene bulkhead wire protectors and / or body grommet type insert ; Must be run in chemical resistant looms and ; Must have wire identification every six ( 6 ) in . Striped wire of assorted colors is acceptable . Cabling Must be of adequate size to handle the anticipated loads of all electrical components ; All cabling must be uninterrupted and complete with no splices ; Terminal ends must be crimped and soldered to the cables and sealed with polyolefin heat shrink tubing . Scotch - Loc fasteners , crimp butt connectors , and wire nuts are not acceptable for any connection ; Weather - pack connections must be protected with dielectric grease and ; All electrical cabling to lamps must be stress relieved within six ( 6 ) in of the lamp .

Idaho

2026-05-11