Shed E Ceiling Fans and Electrical Improvements

2026-11-03

The Work includes , but is not limited to , the following : • Installation of supplemental structural steel spanning between existing precast joists to support four ( 4 ) new large ceiling fans . • Removal of the existing photocell located in panel “ R ,” including conductors , conduits , and accessories , back to the source . • Removal of four ( 4 ) existing exterior disconnects , including associated receptacles , conductors , conduits , and accessories , back to the source . • Removal of four ( 4 ) existing breakers in panel “ R ” feeding the exterior disconnects . • Removal of receptacles and breakers providing power to the existing conveyor in panel “ P3W ,” circuits 8 , 10 , and 12 . • Removal of four ( 4 ) existing 208V , 3 - phase , 5 - wire receptacles ; cap wires and install blank covers . • Patching of all holes left after removal of existing equipment . • Three ( 3 ) new receptacles shall be installed near the kennel area and circuited to panel “ P3W .” • Each receptacle shall be provided with a 20A , 1 - pole breaker , individual neutrals , and approximately 100 feet of 3 / 4 - inch EMT with steel set - screw fittings . Existing conduits may be reused where suitable . • Four ( 4 ) new 16 - foot ceiling fans shall be installed and circuited back to panel “ R .” • Each fan shall be provided with a 25A , 3 - pole breaker in panel “ R .” • Fan circuits shall utilize 3 / 4 - inch EMT with steel set - screw fittings . • A fan controller shall be installed at a location to be determined by the Owner in coordination • with the end user , CBP . • Provide and install a new fire alarm system in full compliance with NFPA 101 , NFPA 72 , and all current requirements of the Authority Having Jurisdiction ( AHJ ).

Florida

2026-05-09