UNR - Install Replacement Heat Exchanger and Control Valves in Mackay Science

2026-11-03

BCN Purchasing does not accept physical documents in response to any solicitation including but not limited to: ITB, RFP, RFQ, or CMAR solicitations. All documents must be submitted electronically via this website.The NGEM system allows for bidders to start and save work/uploads without submitting. Please make use of this capability to begin building your bid early and reduce the chances of internet connectivity or upload issues causing a last-minute inability to submit.Once the ITB/RFP/RFQ/CMAR closes and the responses are unsealed electronically, the list of bidders/responders will be posted online shortly thereafter and available to the public for viewing. This document can be accessed by clicking on Closed Bid Opportunities, selecting the specific opportunity, and scrolling down to Bid Documents. The Bid Tabulation document will be available for review there.Description of Work:This is a prevailing wage project.Replace HTHW heat exchanger, control valves, pumps and associated piping and equipment in Mackay Science. Includes modification to existing electrical, controls, and concrete equipment pads.UNR Project #: 26RPR03601Labor Commissioner #: WA-2027-044SPWD Project #: 26-B082Estimated Cost Range: $274,000 to $374,000Liquidated Damages: $500 per dayRequired Insurance if Awarded:Commercial General Liability, Business Automobile Liability, Workers' Compensation, Pollution Liability, and an Installation Floater will be required. Please refer to the TEMPLATE-Owner-Contractor Construction Agreement on the Attachments tab for limits and additional information and in compliance with the requirements set forth here: https://www.unr.edu/bcn-nshe/risk/contracts.Special Considerations:Site access may be reduced during 2027 Commencement May 10th, 2027 - May 15th, 2027.Work to be performed when not in a heating season. Preferably during summer when the building is mostly unoccupied and the primary heating system is not in use.Qualified welder(s) are required to perform all welding operations for the construction of the high temperature hot water distribution system.Completion of Work: Subject to change by Owner, Work is scheduled to begin on "May 18, 2027" and shall be fully complete by "September 3, 2027."

Nevada

2026-10-31