Water Infiltration Program - Old Main

2026-11-03

1 . Provide and maintain all enclosures , fencing of construction area , interior protection , exterior protection , and ground protection as necessary and as required by Division 01 Section 5000 Temporary Facilities and Controls . 2 . Remove ALL existing joint sealant and back - up material from all window perimeters within the designed exterior walls indicated on the drawing set for the New Addition and provide new back - up material and silicone joint sealant . Refer to Section 07 92 00 – Joint Sealants . a . The approximate lineal footage of window perimeter sealant is 1 , 380 LF . This work item is considered lump sum pricing and the Contractor shall field verify all quantities prior to submitting a bid . 3 . Remove ALL existing joint sealant and back - up material from building control joints at the New Addition portion of the building and provide new back - up material and urethane / paintable joint sealant . Refer to Section 07 92 00 – Joint Sealants . a . The approximate lineal footage of control perimeter sealant is 2 , 150 LF . This work item is considered lump sum pricing and the Contractor shall field verify all quantities prior to submitting a bid . 4 . Remove and replace thru - wall flashing at the New Addition stone tower with new . Refer to Section 07 62 00 – Sheet Metal Flashing and Trim . a . The approximate lineal footage of thru - wall flashing replacement is 15 LF . b . This work item is considered lump sum pricing and the Contractor shall field verify all quantities prior to submitting a bid . 5 . Remove and replace thru - wall flashing at the New Addition penthouse with new . Refer to Section 07 62 00 – Sheet Metal Flashing and Trim . a . The approximate lineal footage of thru - wall flashing replacement is 70 LF . b . This work item is considered lump sum pricing and the Contractor shall field verify all quantities prior to submitting a bid . 6 . Remove and replace existing window thru - wall flashing at the New Addition with new , as noted on the drawing set . Refer to Section 07 62 00 – Sheet Metal Flashing and Trim ...

MITN

2026-04-29